Blog posts by Christian Engvall2012-10-05T14:34:54.0000000Zhttps://world.optimizely.com/blogs/Christian-Engvall/ Optimizely World Unable to publish page containing “URL to image”<p>This error occured after a upgrade from Episerver CMS 5 to CMS 6 R2. When trying to publish a page this error message was shown: &#8220;urltoimage.jpg&#8221;  is not a valid value for &#8220;imageproperty&#8221; Vladimir Terziyski wrote the following about why...</p> <p>The post <a rel="nofollow" href="http://www.christianengvall.se/unable-publish-page-containing-url-image/">Unable to publish page containing &#8220;URL to image&#8221;</a> appeared first on <a rel="nofollow" href="http://www.christianengvall.se">Christian Engvall</a>.</p> 2012-10-05T14:34:54.0000000ZBlog post Upgrading to episerver cms 6<p>I recently ran into the same problem as Jamie Dixon when upgrading a episerver site from cms 5 to cms6. But the solution was a little different. The error message is: Cannot resolve dependencies for the following module(s) EPiServer.Cms.Shell.UI.InitializableModule EPiServer.Cms.Shell.UI.InitializableModule...</p> <p>The post <a rel="nofollow" href="http://www.christianengvall.se/upgrading-episerver-cms-6/">Upgrading to episerver cms 6</a> appeared first on <a rel="nofollow" href="http://www.christianengvall.se">Christian Engvall</a>.</p> 2012-09-27T12:34:34.0000000ZBlog post Check if page in episerver is opened from edit/admin mode<p>This code can be used to check if a page in episerver is opened in edit mode. It uses HttpContext.Current.Request.UrlReferrer.LocalPath to see if the word admin or edit exists in the url. private bool IsOpenedInEditMode() { bool isInEditMode = false;...</p> <p>The post <a rel="nofollow" href="http://www.christianengvall.se/check-page-episerver-opened-editadmin-mode/">Check if page in episerver is opened from edit/admin mode</a> appeared first on <a rel="nofollow" href="http://www.christianengvall.se">Christian Engvall</a>.</p> 2012-09-11T12:39:51.0000000ZBlog post